Skate Sizing

Measuring Your Feet

Skate boots are not like your average shoe. For maximum control, your boots need to fit like a second skin. That is why Bont boot sizing is NOT the same as your US shoe size or other skate brand sizing. As a rule of thumb, Bont sizing is typically two sizes smaller for women and one size smaller for men in US shoe sizes. You will need to measure your feet and compare them to the chart to get the correct sizing.


Wear the type of socks you'll wear with your boots. Distribute weight evenly before measuring


Step 1

On a hard surface, tape a piece of blank paper to the floor. Stand up straight with your foot on the paper. Your heel should be barely touching the wall or not at all. DO NOT push heel into the wall as it will produce incorrect length measurements.

Step 2

Mark the longest part of your foot (heel-to-toe length) and widest part of your foot on the paper with a pen or pencil. If your heel is away from the wall, trace around your whole foot. Make sure your pen is held vertically, not at an angle. Repeat with the other foot, as the right and left foot may be different sizes

Step 3

Use a ruler to measure your heel-to-toe length and width. Take the measurement for each foot. Use these measurements and input them into the size calculator, or compare them to the size chart below.

Size Chart

Please refer to the chart below for the approximate size conversion of foot length in mm to Bont size. If you have any questions, please email: shoeicreations@gmail.com

Size Chart PDF